• Xe Pre-Plumb Solar 2
  • Xe Pre-Plumb Solar 1

Unvented stainless steel cylinders ideal for integration with solar applications to harness the suns energy, to provide environmentally friendly hot water. Popular pre-plumbed model reduces installer installation time by 70%. Quali... Read more

tick

Fast Installation

tick

Excellent ErP Ratings

star

Up to 45% Extra Insulation

crest

25 Year Guarantee*

These cylinders are designed with two indirect heating coils. The primary coil connects to a solar thermal system. The secondary coil is connected to a gas or oil boiler, providing heat when there is insufficient input from the solar heat source. In addition each cylinder features a 3kW electric immersion heater as a secondary backup and to offer a boost to the primary heat source when required.

Features and benefits

  • Up to 70% faster to install
  • ErP 'B' Rated for 180L to 250L cylinders
  • EuP compliant pump with an "A" rating for energy efficiency
  • Up to 45% extra insulation for reduced heat loss
  • Built-in thermal expansion space removing the need for an external expansion vessel
  • Side mounted hot water outlet reduces heat loss, provides better access for solar cylinders that require more space than standard indirect cylinders
  • Can be linked to an additional boiler or a solar thermal system
  • Wide range of capacities - from 180 to 300 litres
  • Separate central heating and hot water zones for maximum efficiency 
  • Choose from single zone or twin zone heating units, twin zone models come with an extra two port valve and additional programmable room thermostat
  • 25-year guarantee on basic vessel and 2-years on components*

*T&Cs apply 25-year guarantee on basic vessel and 2-years on components, see product brochure for more information

Product Code Capacity (ltrs)  Height (mm)  Diameter (mm) ErP Rating  Standing Heat Loss (W) 
 TXSN180P*  180  1371  580  B  50
 TXSN210P*  210  1561  580  B  62
 TXSN250P*  250  1806  580  B  66
 TXSN300P*  300  2076  580  C  77

*For Twin zone models add ‘T’ to the end of the code